:	Sep 13, 2006

: It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.

: Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse connect the battery.

:

If the SRS component is to be replaced, the bar code of the new unit must be recorded.

.

Disconnect the battery ground cable.

.

Make the SRS system safe.

.

Remove the driver air bag module.   Using the special tool, release the clip.   Repeat the above procedure for the other side.   Disconnect the ground cable.   Release the clips and disconnect the 2 electrical connectors.

.

: The SRS electrical connectors are unique. DO NOT force, or attempt to connect electrical connectors to the wrong sockets.   : Make sure the cables/harnesses are not twisted before connecting them to the airbag module. Once connected, do not rotate the air bag module as this will cause the wires to twist, which can lead to harness damage and SRS faults. Attach the driver air bag module.   Connect the ground cable.   Connect the electrical connectors.

.

: Driver air bag module installation can be confirmed by hearing 2 audible clicks, 1 for each spring. The module edges should also be flush with the steering wheel. Install the driver air bag module.   Install top edge of module, then hinge upwards and make sure wires are connected to clips.   Make sure the wires are not trapped behind the module.   Hold wires in place while hinging module closed.   Align the locating pins and springs.